Argyll RuaneHome > Courses > NDT Training Courses > Ultrasonic Testing > Ultrasonic Testing Nozzle (3.8)/Nodes (3.9)/”T” Sections (3.7)

Ultrasonic Testing Nozzle (3.8)/Nodes (3.9)/”T” Sections (3.7)

Important information

Candidates undertaking a PCN examination must fulfil all requirements specified in PCN24/GEN.

For ASNT, EN4179, or NAS410 examinations, candidates must follow the requirements detailed in their organisation’s written practice. This course is not designed as preparation for BGAS-CSWIP examinations.

Practical testing of:

  • Nozzles
  • Nodes
  • Set in preparations
  • Set through preparations
  • Set on preparations
  • Both Part & Full penetration welds

An individual certified to Ultrasonic Testing Level 2 has demonstrated competence to perform NDT according to NDT procedures. Within the scope of the competence defined on the certificate, Level 2 personnel may be authorised by the employer to:

  • Select the Ultrasonic Testing technique for the test method to be used
  • Define the limitations of application of the testing method
  • Translate Ultrasonic Testing codes, standards, specifications and procedures into Ultrasonic Testing instructions adapted to the actual working conditions
  • Set up and verify Ultrasonic Testing equipment settings
  • Perform and supervise Ultrasonic tests
  • Interpret and evaluate results according to applicable standards, codes, specifications or procedures
  • Prepare written Ultrasonic Testing instructions
  • Carry out and supervise all tasks at or below Level 2
  • Provide guidance for personnel at or below Level 2
  • Report the results of Ultrasonic tests.

Certification under the PCN scheme is awarded once a candidate has completed the required training, gained the necessary industry experience, and passed the relevant examinations. The minimum requirements are outlined in full in the PCN24/GEN document.

PCN certification is only achieved when an existing Level 2 Welds certification is held and upon successful passing of the examination.

 

  • Scientific calculator
  • Overalls/Lab coat
  • Safety boots are mandatory in practical areas
  • PCN Candidates: PCN wallet card or other form of photographic identification
  • Pin Profile Gauge (Where possible)

One category

Training course: £531 (2 days)
Examination: £133 (1 day)
PCN Levy: £95
PCN PED Admin Charge: £50
Total: £809

 

Two categories

Training course: £1,063 (4 days)
Examination: £245 (2 days)
PCN Levy: £95
PCN PED Admin Charge: £50
Total: £1,453

 

Three categories

Training course: £1,328 (5 days)
Examination: £368 (2.5 day)
PCN Levy: £95
PCN PED Admin Charge: £50
Total: £1,841

 

Note: Prices are correct at time of issue but may be subject to change, with the exception of confirmed bookings.

Approvals & ACCREDITATIONS